actin binding comes up often in conversation and rarely with the context attached. Here we lay out the basics in order, then work through the practical considerations.
Last reviewed on 2026-01-24. Where a claim depends on a specific study, the study is described rather than over-claimed.
Regulatory status differs by country, but TB-500 is not an approved pharmaceutical in major jurisdictions. It is commonly sold as a research chemical for laboratory use, which places responsibility for identity and purity on the supplier and the laboratory. Published human data are limited, and most reports involve preclinical models or cell culture. Questions about whether the fragment mimics all actions of thymosin beta-4, and under which conditions, remain open. Independent verification of any material is therefore a practical requirement in research settings.
TB-500 is a synthetic heptapeptide with the sequence Ac-LKKTETQ. It corresponds to a short N-terminal region of thymosin beta-4, a 43-amino-acid protein found in many cell types. The fragment contains an actin-binding motif, which is one reason it appears in laboratory studies of cell migration and cytoskeletal dynamics. TB-500 is not the full-length protein and is produced as a research chemical rather than an approved therapeutic agent. Its molecular weight is approximately 889 Da.
Several names appear in scientific and commercial contexts for this peptide. The label TB-500 is informal and does not follow standard biochemical nomenclature. Research articles more often describe the compound as a thymosin beta-4 fragment, Tβ4 fragment, or by its sequence Ac-LKKTETQ. Confusing TB-500 with full-length thymosin beta-4 can lead to incorrect assumptions about activity because the fragment lacks the remaining residues of the parent protein. The relationship between fragment and parent protein remains an active area of study.
Purity and identity are separate measurements and are often confused. Reverse-phase high-performance liquid chromatography, usually with ultraviolet detection near 214 nanometres, reports the share of total peak area belonging to the target compound. Mass spectrometry by electrospray or matrix-assisted laser desorption then checks whether the observed mass matches the expected sequence. Neither measurement alone shows that a vial holds the intended peptide. Peptide content, meaning the fraction of vial mass that is genuine peptide rather than counter-ion, water or residual acid, is reported separately and is frequently lower than the stated purity figure.
The regulatory position is broadly consistent across major jurisdictions: no thymosin beta-4 fragment is an approved medicine, and laboratory material is commonly labelled as not intended for human consumption. Anti-doping rules in sport list thymosin beta-4 and its fragments among prohibited peptide hormones. Because these products travel through research-chemical channels rather than pharmaceutical supply chains, quality varies considerably between vendors. Independent testing of identity, purity and sterility is the only dependable check, and a certificate of analysis describes one batch rather than a supplier's whole catalogue.
Lyophilized peptide powder is normally held desiccated at −20 °C, with −80 °C used for longer storage periods. Allowing a sealed vial to reach room temperature before opening is standard practice, because condensation forming on cold powder introduces moisture. Once dissolved, solutions are typically kept cold and shielded from light. Repeated freeze-thaw cycles are avoided because they encourage aggregation and gradual loss of material. These conventions are general to synthetic peptides rather than unique to any one sequence.
| Property | Value | Notes |
|---|---|---|
| Molecular formula | C38H68N10O14 | Calculated for the acetylated heptapeptide |
| Molecular weight | ~889 Da | Monoisotopic mass approximately 889.0 Da |
| Amino acid sequence | Ac-LKKTETQ | N-terminal acetylated seven-residue peptide |
| Appearance | White to off-white powder | Typically supplied as a lyophilized solid |
| Solubility class | Water-soluble | Peptides of this size generally dissolve in aqueous media |
TB-500 is a synthetic peptide preparation marketed under a name derived from thymosin beta-4, a 43-residue actin-binding protein first isolated from thymus tissue. The full-length protein has a reported molecular mass near 4963 Da, while material sold as TB-500 is often described as a fragment containing the actin-binding motif LKKTETQ. Because suppliers use the name inconsistently, published sources sometimes refer to the same label as a fragment, a synthetic copy, or a related analog. This naming ambiguity complicates direct comparison of reports across studies.
Laboratory work on thymosin beta-4 describes binding to monomeric actin and effects on cell migration, angiogenesis, and inflammatory signaling in cultured cells. Animal models have examined skin, corneal, and cardiac repair after injury, with outcomes reported mainly in preclinical literature. Most of that evidence concerns the parent protein rather than preparations labelled TB-500, so extrapolation from animal findings to a specific commercial product remains uncertain. Whether the two behave identically in living systems has not been established in controlled human studies.
TB-500 is a research peptide whose sequence matches residues 17 to 23 of thymosin beta-4, a 43-residue protein present in most mammalian cells. The chain is seven amino acids long, written as LKKTETQ, and is normally supplied with an acetyl group on the N-terminus. Suppliers list it as a lyophilised powder under the code name TB-500, and the same sequence appears elsewhere in catalogues as the thymosin beta-4 actin-binding fragment. The label is commercial rather than systematic, so no single authority fixes exactly what TB-500 denotes.
Thymosin beta-4 was isolated from calf thymus in the early 1980s and later characterised as an abundant intracellular actin-sequestering protein. Interest in short synthetic fragments grew once the actin-binding motif had been mapped to the middle of the sequence. TB-500 came out of that line of work as a truncated analogue rather than a natural isolate, and it is now sold mainly to laboratories. Published studies on the fragment have been largely in vitro or in animal models, and controlled human trials remain sparse, so claims about effects in people rest on extrapolation.
Literature and online discussion often conflate TB-500 with full-length thymosin beta-4, even though the two differ in size and are not interchangeable in analytical terms. The fragment is produced by solid-phase peptide synthesis, and the product is a defined seven-residue chain rather than a biological extract. Because the term is a trade-style label, two vendors may supply materials of the same nominal sequence but different counter-ion content, purity, or water content. Comparisons across studies are therefore difficult unless the exact sequence and purity are reported.
Research peptides are typically supplied as a white to off-white lyophilised powder in a sealed vial. The dry solid is more stable than a solution and is normally kept refrigerated or frozen until use. Dissolution is usually done in water, phosphate-buffered saline or a similar aqueous medium, depending on the assay. Because the material is hygroscopic and easily contaminated, opening vials in a low-humidity environment and recording the lot number before use are standard laboratory practices.
Once in solution, short peptides are generally less stable than the dry powder, and repeated freeze-thaw cycles are a common cause of loss. Laboratory guidance usually calls for aliquoting on first dissolution and storing aliquots at -20 °C or below, away from light. Adsorption to plastic and glass surfaces can lower measured concentration, particularly at low concentrations, so container material and buffer choice can affect results. Visible cloudiness, colour change or unexpected precipitate is a signal to re-check the material.
TB-500 is a synthetic seven-residue peptide whose sequence, LKKTETQ, matches the N-terminal actin-binding region of thymosin beta-4. It is usually supplied in an N-terminally acetylated form, a modification that blocks the free amino terminus and can influence behavior in solution. In the research literature the same sequence appears under several names, including thymosin beta-4 fragment and shortened thymosin beta-4. Because it is a short peptide rather than the full 43-residue parent protein, its measured properties differ from those reported for thymosin beta-4 as a whole, and the two are not interchangeable in experimental design.
Thymosin beta-4 itself is a small, widely expressed protein that sequesters monomeric actin and participates in cell migration, angiogenesis, and tissue repair. Researchers have examined the shortened fragment as a possible mimic of some of these activities, reasoning that the actin-binding motif lies within the first few residues. Binding to monomeric actin has been observed in cell-free systems. Whether the fragment reproduces the broader effects of the full protein in living tissue remains an open question, and findings from animal models are frequently cited without a clear bridge to human physiology.
=== No development reported === Guanfacine extended release (Connexyn; Intuniv; Intuniv XR; S-877503; SHP-503; SPD-503) – α2-adrenergic receptor agonist [23] Riluzole sublingual (BHV-0223; Nurtec) – various actions [24] Sertraline (Aremis; Besitran; CP-51974; Gladem; Lustral; Serad; Serlain; Tatig; Zoloft) – selective serotonin reuptake inhibitor (SSRI) [25]
Aseptic processing works by placing sterilized food (typically by heat, see ultra-high temperature processing) into sterilized packaging material under sterile conditions. The result is a sealed, sterile food product similar to canned food, but depending on the technique used, damage to food quality is typically reduced compared to canned food. A greater variety of packaging materials can be used as well. Besides UHT, aseptic processing may be used in conjunction with any of the microbe-reduction technologies listed below. With pasteurization and "high pressure pasteurization", the food may not be completely sterilized (instead achieving a specified log reduction), but the use of sterile packaging and environments is retained.
There are frequent misconceptions within both patients and doctors about how hormone replacement therapy affects fertility. One common misconception is that starting it automatically leads to infertility. While it may impact the ability to be fertile, it does not mean it leads to a hundred percent infertility rate. There have been numerous cases of transgender men experiencing pregnancy and abortion. As trans men and doctors can be under this misconception about hormone replacement therapy impacting fertility and serving as a form of contraception, keeping people informed on fertility options remains crucial. For trans women, it is possible for them to undergo cryopreservation before starting hormone replacement therapy. As evidence has shown that trans women tend to have lower motile sperm compared to their cisgender counterparts, fertility preservation can be important for individuals anticipating having biological children in the future. While fertility preservation is important to consider before starting HRT, it is possible in some cases to regain fertility after halting HRT for a period of time. It is also important to educate transgender youth on their fertility preservation options. This is because few adolescents end up doing so, alongside transgender adolescents reporting distress at the prospect of becoming infertile due to medical conditions and treatment relating to their transgender identity.
== Departments == Division of Basic Medical Sciences I Department of Biochemistry Department of General Biology Department of Medical Physics Division of Basic Medical Sciences II Department of Anatomy Department of General Pharmacology Department of Physiology Division of Clinical Laboratories Department of Microbiology Department of Nuclear Medicine Department of Pathology Department of Public Health Department of Radiology Division of Internal Medicine Ι Department of Internal Medicine Division of Paediatrics & Obstetrics – Gynaecology Department of Obstetrics - Gynecology Department of Paediatric Surgery Department of Paediatrics Division of Surgery Department of Anaesthesiology and Intensive Care Department of Cardiothoracic Surgery Department of Neurosurgery Department of Ophthalmology Department of Orthopaedics Department of Otorhinolaryngology Department of Surgery Department of Urology Department of Vascular Surgery
Sources: en.wikipedia.org
The fire continued into a fourth day, when a state of emergency was declared due to the fire continuing to flare up and affecting regional air quality. Shelter-in-place orders were issued in surrounding areas due to the commercial building fire.
=== Shrinkage and swelling === Shrinkage and swelling may occur in wood when the moisture content is changed. Shrinkage occurs as moisture content decreases, while swelling takes place when it increases. Volume change is not equal in all directions. The greatest dimensional change occurs in a direction tangential to the growth rings. Shrinkage from the pith outwards, or radially, is usually considerably less than tangential shrinkage, while longitudinal (along the grain) shrinkage is so slight as to be usually neglected. The longitudinal shrinkage is 0.1% to 0.3%, in contrast to transverse shrinkages, which is 2% to 10%. Tangential shrinkage is often about twice as great as in the radial direction, although in some species it is as much as five times as great. The shrinkage is about 5% to 10% in the tangential direction and about 2% to 6% in the radial direction. Differential transverse shrinkage of wood is related to:
The liquid containing the analytes of interest (typically 10−6 - 10−4 M needed ) is dispersed by electrospray, into a fine aerosol. Because the ion formation involves extensive solvent evaporation (also termed desolvation), the typical solvents for electrospray ionization are prepared by mixing water with volatile organic compounds (e.g. methanol acetonitrile). To decrease the initial droplet size, compounds that increase the conductivity (e.g. acetic acid) are customarily added to the solution. These species also act to provide a source of protons to facilitate the ionization process. Large-flow electrosprays can benefit from nebulization of a heated inert gas such as nitrogen or carbon dioxide in addition to the high temperature of the ESI source. The aerosol is sampled into the first vacuum stage of a mass spectrometer through a capillary carrying a potential difference of approximately 3000 V, which can be heated to aid further solvent evaporation from the charged droplets. The solvent evaporates from a charged droplet until it becomes unstable upon reaching its Rayleigh limit. At this point, the droplet deforms as the electrostatic repulsion of like charges, in an ever-decreasing droplet size, becomes more powerful than the surface tension holding the droplet together. At this point the droplet undergoes Coulomb fission, whereby the original droplet 'explodes' creating many smaller, more stable droplets. The new droplets undergo desolvation and subsequently further Coulomb fissions.
Sources: en.wikipedia.org
TB-500 is a synthetic heptapeptide corresponding to a fragment of thymosin beta-4. It is used in laboratory research and is not an approved drug.
No. Thymosin beta-4 is a 43-amino-acid protein, while TB-500 represents only a short N-terminal segment. The two should not be treated as interchangeable in experimental design.
It is often called a thymosin beta-4 fragment, Tβ4 fragment, or Ac-LKKTETQ. The name TB-500 is mainly a commercial or catalog label rather than a formal chemical name.
Desiccated storage at −20 °C is conventional, with −80 °C for extended periods. Vials should be warmed to room temperature before opening to prevent condensation on the powder.