The short version of peptide mapping fits in a sentence. The long version — which is the one that helps — is below.
This page was last updated on 2025-09-22 and is reviewed periodically as new material appears.
TB-500 is a synthetic seven-amino-acid peptide with the sequence LKKTETQ, corresponding to residues 17 through 23 of the protein thymosin beta-4. The N-terminus is typically acetylated in the described form, giving a monoisotopic mass near 888.5 Da and an average mass of about 889 Da. The designation TB-500 is a catalogue label rather than a formal chemical name, and the same sequence appears in the literature under several alternative abbreviations. It is handled as a research reagent rather than a pharmaceutical product.
Thymosin beta-4 is a 43-residue actin-binding protein found in most mammalian cell types, where it participates in cytoskeletal regulation and cell migration. TB-500 represents only a short fragment of that protein and does not include the remaining residues. Whether the isolated fragment reproduces the full range of activities reported for the intact protein remains an open question. Researchers commonly treat the two as related but distinct entities when comparing results.
Published work involving this sequence spans actin-binding assays, cell-migration studies, wound-healing models, and cardiovascular or musculoskeletal experiments. Much of the biological rationale derives from in vitro systems and animal models, and the number of controlled human studies is small. Reported outcomes vary across preparations, doses, and routes, which complicates comparison between studies. Reviews generally describe the evidence base as preliminary rather than settled. Mechanistic explanations are often proposed by analogy to the parent protein rather than demonstrated directly.
Research peptides are typically supplied as a white to off-white lyophilised powder in a sealed vial. The dry solid is more stable than a solution and is normally kept refrigerated or frozen until use. Dissolution is usually done in water, phosphate-buffered saline or a similar aqueous medium, depending on the assay. Because the material is hygroscopic and easily contaminated, opening vials in a low-humidity environment and recording the lot number before use are standard laboratory practices.
Once in solution, short peptides are generally less stable than the dry powder, and repeated freeze-thaw cycles are a common cause of loss. Laboratory guidance usually calls for aliquoting on first dissolution and storing aliquots at -20 °C or below, away from light. Adsorption to plastic and glass surfaces can lower measured concentration, particularly at low concentrations, so container material and buffer choice can affect results. Visible cloudiness, colour change or unexpected precipitate is a signal to re-check the material.
| Property | Value | Notes |
|---|---|---|
| Molecular formula | C38H68N10O14 | Acetylated heptapeptide form |
| Monoisotopic mass | 888.5 Da | Average mass about 889 Da |
| Appearance | White to off-white solid | Usually supplied as lyophilised powder |
| Solubility class | Highly water soluble | Also dissolves in aqueous buffers |
| Common synonyms | Tbeta4 fragment, thymosin beta-4 (17-23) | Refer to the same sequence |
Lyophilized peptide powder is normally held desiccated at −20 °C, with −80 °C used for longer storage periods. Allowing a sealed vial to reach room temperature before opening is standard practice, because condensation forming on cold powder introduces moisture. Once dissolved, solutions are typically kept cold and shielded from light. Repeated freeze-thaw cycles are avoided because they encourage aggregation and gradual loss of material. These conventions are general to synthetic peptides rather than unique to any one sequence.
Purity and identity are separate measurements and are often confused. Reverse-phase high-performance liquid chromatography, usually with ultraviolet detection near 214 nanometres, reports the share of total peak area belonging to the target compound. Mass spectrometry by electrospray or matrix-assisted laser desorption then checks whether the observed mass matches the expected sequence. Neither measurement alone shows that a vial holds the intended peptide. Peptide content, meaning the fraction of vial mass that is genuine peptide rather than counter-ion, water or residual acid, is reported separately and is frequently lower than the stated purity figure.
The fragment most often associated with the name carries the sequence Ac-LKKTETQ, matching residues 17 through 23 of thymosin beta-4. That region holds the actin-binding motif responsible for much of the parent protein's biochemical activity. Apart from N-terminal acetylation the peptide is unmodified and contains no disulfide bonds, so it shows little ordered secondary structure in solution. Full-length thymosin beta-4 is instead a 43-residue polypeptide of roughly 4.9 kDa found widely across mammalian cell types.
Material sold under this label typically arrives as a freeze-dried powder in a sealed vial with a certificate of analysis. Such certificates usually report reversed-phase chromatography purity plus a mass confirmation, and stated purities commonly sit between 95 and 99 percent. Counter-ion identity, residual trifluoroacetate, water content, and peptide net weight are separate specifications that a certificate may or may not include. A purity figure alone does not establish sequence identity, so independent mass verification remains the practical check.
Lyophilised peptide powders are hygroscopic, and the fragment absorbs atmospheric moisture when a vial is opened at room temperature. Weighing and aliquoting are normally done quickly in a dry environment, and stock solutions are divided into single-use portions before freezing. Repeated freeze-thaw cycles are avoided because they promote aggregation and can shift the measured content of a vial. These practices are general to synthetic peptides rather than unique to this sequence, but they matter more for short chains kept for long periods.
The seven-residue chain carries several polar and charged side chains, so it dissolves readily in water and in aqueous buffers near neutral pH. No cysteine is present, so disulphide formation is not a concern and reducing agents are unnecessary. Dilute ammonium hydroxide or acetonitrile-water mixtures are sometimes used for stock solutions when initial dissolution is slow. Strongly alkaline conditions and prolonged contact with oxidising agents are avoided because they can modify lysine-containing stretches, and haze in solution usually signals incomplete dissolution or aggregated material.
Identity and purity are checked with reversed-phase high-performance liquid chromatography, which separates the target sequence from truncated or deletion analogues, and with mass spectrometry, which confirms the expected molecular mass. Amino acid analysis and peptide mapping give orthogonal confirmation but are used less often outside specialist laboratories. Counter-ion content varies: material purified on trifluoroacetic acid gradients retains trifluoroacetate, and ion exchange can convert the salt form. Residual water and solvent are measured by Karl Fischer titration or thermogravimetric analysis, and any purity figure should be read together with the method used to obtain it.
Over the years, Ferasse has resisted Eastern Bloc pressure to break with South Africa. At one point Moscow threatened to set up a rival Federation, but the Rumanians, with whom the French have long had good relationships, stood by France. Moscow tried again later by threatening to call off the France v. USSR match in Toulouse in November 1978. Once again Ferasse held firm and the Russians went to France, where they were beaten 29-7 In September 1981, South Africa was due to play the Mid-West in Chicago. To avoid protestors, they drove 77 miles to Racine and played in front of 247 spectators, winning 46–12. By the time they returned to Chicago, none of the protestors knew that the game had happened. In 1989 a World XV, sanctioned by the IRB and funded by South African Breweries, played two tests against South Africa in 1989 in celebration of the centenary of the South African Rugby Board (SARB). The Springboks won both, by 20–19 at Newlands Stadium in Cape Town and the second test 22–16 on 2 September at Ellis Park in Johannesburg .
The exception is the gasoline engine powered unit, which requires a much higher level of training and topside supervision for safe use. The air-line breathing air compressor compresses clean atmospheric air and stores it in a receiver tank, using an overpressure valve to limit the pressure. The air passes through a filter and the air hose to the diver's demand valve. Small 12 volt diaphragm compressors are used for recreational hookah, with a delivery of around 1.8 bars (26 psi), which severely limits the depth to which air can be supplied. The rubber diaphragm pump usually requires no oil lubricant and delivers oil-free air. Piston compressors for hookah deliver air at higher pressures, up to about 9 bars (130 psi), and are usually driven by a small 4-stroke petrol engine. They are usually oil lubricated, using a breathing air rated mineral or synthetic oil without toxic additives. This type of compressor requires a filter to clean the air before delivery to the diver. Delivery pressure for 12 metres (39 ft) is about 20 to 35 pounds per square inch (1.4 to 2.4 bar) using a hookah regulator. Depths of 40 metres (130 ft) require up to 9 bars (130 psi). The pressure relief valve will blow off excess air delivered at low demand, to protect the system from overpressure loads, while delivering sufficient air for higher exertion. The air line hose should be rated for breathing air, with a bore of 8 to 10 millimetres (0.31 to 0.39 in). It is usually buoyant to minimise snagging on the bottom, particularly if not tended from the surface.
Atmospheric pressure photoionization (APPI) is a soft ionization method used in mass spectrometry (MS) usually coupled to liquid chromatography (LC). Molecules are ionized using a vacuum ultraviolet (VUV) light source operating at atmospheric pressure (105 Pa), either by direct absorption followed by electron ejection or through ionization of a dopant molecule that leads to chemical ionization of target molecules. The sample is usually a solvent spray that is vaporized by nebulization and heat. The benefit of APPI is that it ionizes molecules across a broad range of polarity and is particularly useful for ionization of low polarity molecules for which other popular ionization methods such as electrospray ionization (ESI) and atmospheric pressure chemical ionization (APCI) are less suitable. It is also less prone to ion suppression and matrix effects compared to ESI and APCI and typically has a wide linear dynamic range. The application of APPI with LC/MS is commonly used for analysis of petroleum compounds, pesticides, steroids, and drug metabolites lacking polar functional groups and is being extensively deployed for ambient ionization particularly for explosives detection in security applications.
Sources: en.wikipedia.org
=== 1980–2009: Expansion globally === As the Japanese economy worsened in the 1980s, Ajinomoto sought to outsource more of its production overseas, which increased the number of employees the company employed overseas from 4,000 in 1979 to more than 11,000 in 1996. Starting in 1980, Ajinomoto began to refocus its diversification efforts from food products to its amino acid business. Following the US FDA's re-approval of aspartame in 1981, Ajinomoto began producing the sweetener at its Tokai factory in 1982. In 1987, Ajinomoto began researching drug development in the fields of clinical nutrition, anti-cancer drugs, infectious diseases, and cardiovascular drugs. Through this research, the company developed ELENTAL for use in clinical nutrition, LIVACT to fight liver disease, and Lentinan in collaboration with the Japanese Foundation for Cancer Research. Ajinomoto later released JINO as a cosmetic and amino acid for athletes, followed by Amino Vital, a supplement to JINO released in 1995. In 2000, Ajinomoto acquired NutraSweet and Euro-Aspartame from Monsanto. In December 1995, Ajinomoto's Philippine CEO and President Leonardo K. Ty was assassinated by two members of the communist guerrilla group Alex Boncayao Brigade. The group cited Ty's allegedly poor safety standards for one of his other companies that they claimed to have led to the deaths of several of his employees. Ty had been head of Union Ajinomoto Inc. with his brother Alejandro since the late 1960s, and prior to his death, Ty had been seeking the protection of the National Bureau of Investigation.
Silver salts have antiseptic properties. In 1881 Credé introduced a method known as Credé's prophylaxis, which used of dilute (2%) solutions of silver nitrate in newborn babies' eyes at birth to prevent contraction of gonorrhea from the mother, which could cause blindness via ophthalmia neonatorum. (Modern antibiotics are now used instead). Fused silver nitrate, shaped into sticks, was traditionally called "lunar caustic". It is used as a cauterizing agent, for example to remove granulation tissue around a stoma. General Sir James Abbott noted in his journals that in India in 1827 it was infused by a British surgeon into wounds in his arm resulting from the bite of a mad dog to cauterize the wounds and prevent the onset of rabies. Silver nitrate is used to cauterize superficial blood vessels in the nose to help prevent nosebleeds. Dentists sometimes use silver nitrate-infused swabs to heal oral ulcers. Silver nitrate is used by some podiatrists to kill cells located in the nail bed. The Canadian physician C. A. Douglas Ringrose researched the use of silver nitrate for sterilization procedures, believing that silver nitrate could be used to block and corrode the fallopian tubes. The technique was ineffective.
== Health uses == Lemonheads are sometimes recommended by pregnant women for the relief of nausea commonly caused by morning sickness during pregnancy. Those undergoing chemotherapy are also sometimes advised to suck on Lemonheads or other sour lemon candies, as these promote salivation.
Sources: en.wikipedia.org
No. TB-500 is a short synthetic peptide matching residues 17 to 23 of thymosin beta-4, while the parent protein contains 43 residues. The fragment lacks the rest of the protein sequence, so the two are related but not identical.
It consists of leucine, lysine, lysine, threonine, glutamic acid, threonine, and glutamine in that order. The N-terminal leucine is usually acetylated in the forms described in catalogues.
Controlled human data is limited, and most published findings come from cell culture or animal work. This makes it difficult to state clinical effects with confidence.
Sealed, desiccated and protected from light, at -20 °C or lower for long-term storage. Short-term storage at refrigerator temperature is common in working laboratories.